Dhcp Clients List; Address Reservation - TP-Link TL-WA730RE User Manual

Note:
1 When the device is working on Dynamic IP mode, the DHCP Server function will be disabled.
2 To use the DHCP server function of the device, you should configure all computers in the LAN
as "Obtain an IP Address automatically" mode. This function will not take effect until the device
reboots.

4.6.2 DHCP Clients List

Selecting DHCP > DHCP Clients List will enable you to view the Client Name, MAC Address,
Assigned IP and Lease Time for each DHCP Client attached to the device (Figure 4-19).
ID - Here displays the index of the DHCP client.
Client Name - Here displays the name of the DHCP client.
MAC Address - Here displays the MAC address of the DHCP client.
Assigned IP - Here displays the IP address that the AP has allocated to the DHCP client.
Lease Time - Here displays the time of the DHCP client leased. Before the time is up, DHCP
client will request to renew the lease automatically.
You cannot change any of the values on this page. To update this page and to show the current
attached devices, click on the Refresh button.

4.6.3 Address Reservation

Selecting DHCP > Address Reservation will enable you to specify a reserved IP address for a
PC on the LAN, so the PC will always obtain the same IP address each time when it accesses the
AP. Reserved IP addresses should be assigned to servers that require permanent IP settings. The
screen below is used for address reservation (shown in Figure 4-20).
TL-WA730RE 150Mbps Wireless Range Extender User Guide
Figure 4-19 DHCP Clients List
Figure 4-20 Address Reservation
39