Advertisement
1.
Raise rear body cover to fully open position.
2.
Install flat washer on right hand swivel plate weldment. Next install right
hand control lever, then second flat washer.
3.
Push control lever into the neutral slot and install (2) cup washers,
(1) flat washer and jam nut. (See Illustration)
4.
Tighten jam nut. Proper tightness or tension on jam nut is achieved
when swing out movement of upper control levers requires some pressure.
Levers should not fall to the side or be sloppy in movement.
5. Repeat above procedure on left side.
UPPER CONTROL LEVER INSTALLATION
Page 8
Advertisement
