Controls - Dixon ZTR 5000 Series Operator's Manual

BLADE DRIVE:
Located on control panel, on operator's right.
1998 Models
To engage blades: Slide switch to rear and flip
up and forward.
To disengage blades: Flip switch down.
1999 Models
To engage blades: Pull switch up.
To disengage blades: Push switch down.
CIRCUIT BREAKER:
Located on control panel, on operator's right.
Protection of the electrical system is by (1)15
amp circuit breaker.
If circuit breaker trips, push button to reset.
If this cpndition repeats, consult dealer for
inspection and repair.
MOWER DECK CUT HEIGHT LIFT LEVER:
Located to the right and front of operator. Controls the
cutting height. Seven positions of adjustment.
Depress trigger and move lever forward to lower
deck.
Depress trigger and pull lever back to raise deck.
Page 14

CONTROLS

NOTE: Always use high position for transport.