Table of Contents
Advertisement
Installing and Connecting
Connecting SNT-1010
To Connect the Power
3
Power Cable
1
Connect the AC adapter to the Power port of the SNT-1010.
2
Connect the power cable to the AC adapter.
3
Plug the power plug into the wall outlet.
If the power is connected,the [POWER]LED is turned on.
Use AC adapter authorized by the company only. (DC 8.4V/1A)
Notice
18
(Continued)
2
1
AC Adapter
SNT-1010
Network Connection & Setup
You can set up the SNT-1010 network settings according to your network configurations.
SNT-1010 network connection and setup processes are given as follows.
Connect SNT-1010 to an IP sharer with a xDSL/Cable modem
Connect SNT-1010 to an IP sharer with local area networking
Connect SNT-1010 directly to a DHCP-based xDSL/Cable modem
Connect SNT--1010 directly to local area networking
SNT-1010 compliant IP sharers are as listed below.
- LINKSYS WRT54G
Note
- D-LINK DI-624
- NETGEAR WGT624
Do not use other IP sharers than SNT-1010 authorized ones.Otherwise, it can cause a network error.
Depending on the performance of the PC (Viewer installed)or the network,the video transmission can be
delayed or even disconnected. For soft video transmission,you can set the bandwidth in <NETWORK>
<STREAMING SETUP> under the SNT-1010 setup menu.
LINKSYS WRT54G IP sharer is taken example for the description of the IP settings in this manual.
For more information on the third party's IP sharer, refer to the product's documentation.
The IP and MAC addresses used in this manual are for illustrative purposes only.Therefore,you must refer to
the network settings of your PC and do not enter the addresses presented in this manual.
Notice
Page 20
Page 25
Page 30
Page 31
19
Advertisement
Table of Contents
