Items Required For Operation - THUNDER TIGER SLEDGE HAMMER S50 Manual

ITEMS REQUIRED FOR OPERATION

Screw Drivers, Lexan Body Reamer, Hobby Knife,
Lexan Scissors.
TOOL INCLUDED
Hex Wrench Set, 2.0mm / 2.5mm / 3.0mm / 5.0mm
, 2.0mm / 2.5mm / 3.0mm / 5.0mm
No.2932 Ni-MH battery
Pack/Hump, 6V/1200mAh 2/3A
Note:
Battery life is short when using Alkaline batteries. For safety, we recommend using Alkaline batteries for only 30 minutes
before testing; mostly changing. Battery strength affects braking power and radio range. If voltage drops while running the
car, you will loose control and destroy your car! This is NOT covered under warranty. To increase run time, upgrade receiver
battery to a 5-cell flat /hump pack (TT#2932 Hump). But, the most important step you can make, "is to always use fully charged
or fresh batteries when running your car".
TT#2932 5-Cell 6V Hump
PRO-START Engine Starter
MTA-4 Hex Drive
Starting Shaft
MTA-4 Nut Wrench
*AA Rechargeable Ni-MH
battery 4 pieces for receiver
Fuel Bottle
AA Alkaline dry batteries 8
pieces for transmitter
Glow Fuel, Methanol 10% to 30%
Nitro 5% to 18% Caster / Synthetic Oil
10%~30%
5%~18%
5-Way Wrench
Glow Starter w/ Charger