Advertisement
2 GB (2 x 1 GB Kit) PC2-3200 CL3 ECC DDR2 SDRAM
RDIMM (39M5809)
4 GB (2 x 2 GB Kit) Dual Rank PC2-3200 CL3 ECC DDR2
SDRAM RDIMM (39M5812)
4 GB (2 x 2 GB Kit) Single Rank PC2-3200 CL3 ECC
DDR2 SDRAM RDIMM (39M5815)
8 GB (2 x 4 GB Kit) PC2-3200 CL3 ECC DDR2 SDRAM
RDIMM (30R5145)
Power considerations: The xSeries 336 sever includes a
standard 585-watt power supply.
capable of providing sufficient power to run the server
fully configured with supported devices.
Cable orders:
The dual 10/100/1000 Mbps, full-duplex,
Ethernet PCI controllers, standard with the xSeries 336
server, are connected directly to independent RJ-45
connectors. The RJ-45 connectors provides a 10/100/1000
Base-T interface (either at half- or full-duplex) for
connecting twisted-pair cable to the Ethernet network.
Cabling is not included with the server. To connect the
Ethernet controller to a repeater or switch, use a UTP
cable with RJ-45 connectors at both ends. For 100 Mbps,
or higher, Category 5e, or better, cabling must be used.
There are no additional cabling requirements, other than
for
system
power,
keyboard,
connections.
Installability: The xSeries 336 server requires about 20
minutes for installation. Installation includes unpacking,
setting up, and powering on the system. Additional time
is required to install an operating system, additional
adapters, or features.
Packaging
One box
System unit carton: System unit
Country kit carton
Power cord
xSeries 336 Installation Guide
Rack Installation Guide
ServeRAID
Support Package
Velcro/cable tie package
11
CD-ROM packages
Cable Management Arm
11
Documentation, ServerGuide, IBM Director, Broadcom
The xSeries 336 server is shipped in a single package.
The country kit carton is contained inside the top portion
of the system unit carton.
Processor upgrade options
Intel Xeon processor
Safety instructions/warranty
Security, auditability, and control
Security and auditability features include:
Power-on and privileged-access password functions
provide controls of who has access to the data and
server setup program on the server.
A set unattended boot mode allows the system
keyboard to be locked to all entries except the
password
and
at
the
computers on the network to access the system disk
drive.
This power supply is
mouse,
and
monitor
same
time
allows
other
A selectable boot sequence can be used to prevent
unauthorized installation of software or removal of
data from the diskette drive.
These servers are intended to be installed and secured
in a rack. It is a customer s responsibility to ensure that
the server and rack installation are secure to prevent
sensitive data from being removed.
The customer is responsible for evaluation, selection, and
implementation
of
security
procedures, and appropriate controls in application
systems and communications facilities.
Terms and conditions
IBM Global Financing: Yes
To obtain copies of the IBM Statement of Limited
Warranty, contact your reseller or IBM.
In the United States, call 800-IBM-SERV (426-7378) or
write to:
Warranty Information
P.O. Box 12195
Research Triangle Park, NC 27709
Attn: Dept JDJA/B203
Warranty period
System hardware — Three years
Optional features — One year
Optional IBM features initially installed in an IBM system
carry the same warranty period as the system. If installed
after the initial system installation, they carry the balance
of the system warranty or the optional feature warranty,
whichever is greater.
Warranty service:
If required, IBM provides repair or
exchange service depending on the type of warranty
service specified for the machine.
resolve your problem over the telephone or electronically
by access to an IBM Web site.
problem determination and resolution procedures that
IBM specifies. Scheduling of service will depend upon the
time of your call and is subject to parts availability.
Service levels are response time objectives and are not
guaranteed. The specified level of warranty service may
not be available in all worldwide locations.
charges may apply outside IBM s normal service area.
Contact your local IBM representative or your reseller for
country- and location-specific information.
Customer replaceable unit (CRU) (for example, keyboard,
mouse, speaker, memory, or HDD) service and on-site
service for other selected parts.
CRU service: IBM provides replacement CRUs to you for
you to install.
CRU information and replacement
instructions are shipped with your machine and are
available from IBM at any time on your request. CRUs
are designated as being either a Tier 1 or a Tier 2 CRU.
Installation of Tier 1 CRUs is your responsibility. If IBM
installs a Tier 1 CRU, at your request, you will be charged
for the installation. You may install a Tier 2 CRU yourself
or request IBM to install it, at no additional charge under
the type of warranty service specified, on-site service.
Based upon availability, CRUs will be shipped for
next-business-day (NBD) delivery.
materials shipped with a replacement CRU whether a
defective CRU must be returned to IBM. When return is
required, return instructions and a container are shipped
-5-
features,
administrative
IBM will attempt to
You must follow the
Additional
IBM specifies in the
106-239
Advertisement
