Using; When A Vcr Is Installed - Dish Network EZ User Manual

16.If the information in step 2 on page 15 is a "3,"
write the numbers you circled in Table 2 into the
blank in step 21.
17.If the information in step 2 on page 15 is a "4,"
write the numbers you circled in Table 2 into the
blank in step 21, except replace the "3" with a "4."
18.Press and hold
on (it takes about five seconds).
19.Release
20.Press the
21.Press
22.Press the MUTE button while watching
SAT
23.If the
If
SAT
24.Press
VCR change to the channel you wrote in step 21
above so that you can watch satellite programming.
25.Press the
receiver
step 15 on page 18.
26.You are finished programming the remote control.
U
SING
If you installed a VCR using the instructions in Setting Up
to Pass Satellite Programming Through Your VCR to
Your TV on page 14, but you would like to use
switch your TV to the preferred off-air channel, make sure
your VCR is turned off before pressing
20
.
SAT
RECALL
light.
light flashes three times, go to step 24.
SAT
light does not flash at all, go back to step 18.
. You should see both your TV and your
button. If you see the satellite
MENU
screen, go to step 26. If not, go to
Menu
W
HEN A
until both
light will flash.
button.
VCR
SAT lights turn
TV
.
I
IS NSTALLED
.
to
118866