Dish Network VIP612 Remote Control Setup page 13

1
Model ID ViP612 CVR-SD
Receiver CAID R0079256789-30
Smart Card ID S1907972574-12
DNASP206 Dsh689
Software Version AEE2WAND-N
Boot Strap Version 1010WAND
Billing & Programming 1-800-333-DISH(3474)
Technical Assistance 1-800-333-DISH(3474)
Internet Address dishnetwork.com
Receiver Mode Single Mode
Location ID 87940875:00000004
Remote Address IR/UHF Pro Band A
Help Done Cancel
Display System Information
screen and note the
Remote Control Address
1
Turn on the other receiver and display the System Info screen as described in that user's
guide.
Write down the remote control address:
2
Press and hold AUX until all the other mode buttons light up, and then let go of the button.
AUX flashes.
3
Press the 3 button.
4
Use the NUMBER PAD to enter the address you wrote in step 1.
5
Press POUND (#). AUX blinks three times.
6
Press RECORD to ensure the address in the remote matches the address on the receiver.
T R B
HE ECOVER
Use RECOVER if you accidentally change the TV channel or video input and have a
snowy, blue, or black screen on your TV. When you press RECOVER as described below,
the remote control sends commands to your TV to change channels or video inputs to get
back to watching satellite programming. This procedure works only if you have
accidentally changed the TV channel or video input. It does not recover lost satellite signal
(see Troubleshooting Tables on page 100 for information on solving problems).
Note: The remote control must be programmed to operate the TV (and VCR, if applicable)
for RECOVER to work as described. RECOVER will first try to tune your TV to channel 3,
then channel 4, and then other video inputs with each press of RECOVER. You may need
to press RECOVER multiple times to recover your satellite TV video.
Using the Recover Button
To use RECOVER, the remote control must be programmed to operate the TV and, if
installed, the VCR.
3
2
Press the
3 button
AUX
Press and hold the
AUX Mode buttton until all
Mode butttons light up
(Button will Flash)
UTTON
Remote Control Setup
The Recover Button
4
5
Press POUND
Enter remote
(AUX button
address from step
will flash 3 times)
one
6
Press
RECORD
73