Grounding Instructions - Kenmore 7754 - Elite 30 in. Gas Range Installation Instructions Manual

PLEASE READ CAREFULLY! Forpersonal
safety, t hisproduct m ustbeproperly g rounded.
Grounding
Instructions
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle to minimize the possibility
of electric shock hazard from this appliance. The customer
should have the wall receptacle and circuit checked by a
qualified electrician to make sure the receptacle is properly
grounded and polarized.
Preferred
Do Not, Under
Power Supply
Grounding Cord with
Type 3=Prong
Wall Grounding
Receptacle Plug
6.Assembly of the Surface Burner Heads, Burner
Caps and Burner Grates:
It is very important to make sure that all of the Surface Burner
Heads, Surface Burner Caps and Surface Burner Grates are
installed correctly.
Your appliance was shipped with the burner heads and burner
caps assembled in the correct locations (See Fig. 1).
Should you need to re-install the burner caps please refer to
the Use & Care Guide for more information.
REMEMBER--DO NOTALLOW SPILLS, FOOD, CLEANING
AGENTS ORANY OTHER MATERIAL TO ENTER THE GAS
ORIFICE HOLDER OPENING. Always keepthe Burner Caps
and Burner Heads in place whenever the surface burners are
in use.
Burner sizes and cooktop locations
Where a standard two-prong wall receptacle is encountered,
it is the personal responsibility and obligation of the customer
to have it replaced with a properly g rou nded three-prong wall
receptacle.
DO NOT, UNDERANY CIRCUMSTANCES, CUT OR REMOVE
THE THIRD (GROUND) PRONG FROM THE POWER CORD.
1. 5,000 BTU Simmer Burner. Fig. 1
2. 9,500BTU Bridge Burner.
3. 9,500 BTU Power Burner(some models).
4. 14,200 BTU Power Burner (some models).
5. 3,000 to 18,000 BTU Double Burner (some models).