Step 12 - Directed Electronics G322R Owner's Installation Manual

step 12

Testing the system
With all the previous steps completed, the operation of the
system can now be tested.
Close all the doors and press the button on the transmitter,
the system should chirp one time.
At this point the system will go through diagnostics, a 15 second
process in which the security system will analyze the status of all
connected zones.
After 15 seconds open the driver side door, the alarm should
emit a series of chirps to indicate a security breach, after several
chirps the system will go into full trigger and the siren will
sound.
At any point during the chirps or full trigger press the but-
ton again and the system should turn off.
Rearm the system and test the remainder of the doors.
After testing the doors sit in the vehicle and close the doors,
rearm the system and after 15 seconds turn the key on, the sys-
tem will emit a series of chirps and then go into full trigger, at
this time attempt to start the vehicle it should NOT crank.
Press the button on the transmitter to disarm the system
and cycle the ignition key off, on, off to reset the system.
Rearm the system, wait 15 seconds and lightly bump the tire
with your foot, the system should emit a series of chirps, kick the
tire a little harder and the system should go into full trigger.
Disarm the system.
This completes the testing, if all functions and zones do not
© 2003 directed electronics, inc. 19