Step 2; Step 11 - Directed Electronics G322R Owner's Installation Manual

feed the wires through the hole and press the switch firmly until
it snaps into place. Run the wires to the same location as the LED
using caution to NOT run the wires near any moving objects or
excessive heat.

step 2

Ground Wire
The BLACK wire on the main 8-pin harness is ground. This wire
should be connected to a clean, paint-free area of metal in the
drivers kick panel area. First strip back a ¾-inch section of the
insulation off the BLACK wire and crimp a ring terminal (not
provided) to that wire. Locate a clean, paint-free metal surface in
the drivers kick panel. Using a self-tapping screw, drill the screw
with the ring terminal to the metal area. Once screwed down,
pull on the wire to ensure a good connection.
note: More problems are attributed to poor ground con-
nections than any other cause. Take extra care to ensure
the ground is clean and secure.
© 2003 directed electronics, inc. 9