Directed Electronics Python 990 Owner's Manual page 49

Directed electronics combination remote start alarm system owner's manual 990
Hide thumbs Also See for Python 990:
Table of Contents

Advertisement

from 1 to 180 seconds.
Automatic Engine Disable (AED) on or o o f f f f . The purpose of
this feature is to protect the vehicle from being stolen at all
times, regardless of whether or not the alarm is armed. If
AED is programmed on, the starter of the vehicle will be
disabled 30 seconds after the ignition is turned off. Once the
key is turned off, the LED will flash slowly (one-half its
normal armed rate) to indicate the AED arming cycle.
Thirty seconds later, the starter will be disabled. To start the
car, it will be necessary to disarm the system with the trans-
mitter. It is also possible to disarm the AED feature by
turning the ignition key to the RUN position and pressing
the Valet button the programmed number of times. AED is
also disabled when the system is in Valet mode.
note: This feature will only function if the FailSafe
Starter Kill relay has been installed.
Siren tones and chirp volume. The output of the Revenger
Soft Chirp
Any of these tones can be eliminated by a dealer, resulting in a
unique, easily identifiable siren sound. The chirps can be either
full volume or 6 6 d d e e c c i i b b e e l l s s q q u u i i e e t t e e r r than the full alarm blast.
12, 24, or 60 minute run time. your system can be
programmed to allow the vehicle to run for 12, 24, or 60
minutes when remote started. Can be set up to minute
increments by your installer.
3, 6, 9, or 12 minute timer mode run time. Your system can
46
siren consists of six different tones in sequence.
© 2006 directed electronics—all rights reser ved
®

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents