Attaching The Adjusting Rail To The Door Panel (Refrigerator Compartment); Attaching The Fixation Strips To The Door Panel (Refrigerator Compartment) - Thermador T36IT800NP Installation Instructions Manual

7. Attaching the adjusting rail to
the door panel (refrigerator
compartment)
1. Measure the distance A between the adjusting rail
and the overhead cabinet/fixtures.
2. Loosen the 2 nuts (a) and remove the adjusting
rail (b).
3. Mark this amount A on the rear of the door panel.
4. Determine and mark the centerline of the door panel.
5. Put on the adjusting rail and align along the marks.
Mark the drill holes.
6. Drill the holes.
7. Screw on the adjusting rail tightly.
20
Notes:
Attach the adjusting rail to the door panel with at

least 6 screws. One screw should be inserted under
each double threaded bolt.
The adjusting rail features a variety of holes for the

many different design options of door panels.
Always screw into the best load-bearing material of
the door panel.
8. Attaching the fixation strips to the
door panel (refrigerator
compartment)
Note:
The fixation strips are pre-assembled for stainless steel
doors. In this case continue with the next installation step
("C / 9. Attaching the adjusting rail to the door panel
(freezer compartment)").
1. Hang the door panel on the double threaded
bolt (a).
2. Align the door panel with the double threaded bolts
(Torx screwdriver).
Re-examine the dimensions of the gap continuously.
Use the height adjustment gauge (b).
3. Transfer the middle drill holes along the outer edge
of the appliance door to the door panel and mark.