Rear Panel Lacks - Samsung HCM4715W Instructions Manual

Your NEw TV ]
Rear Panel Jacks
Use the zear parle] jacks to connect an A/V component that will be connected conthlu
ously, such as a VCR or a DVD player.
Because theze are two sets of inputjacks, you can connect two different A/V components
(i.e., a VCR and a DVD, 2 VCRs, etc.)
For more inf_rmation oil connecting equipment, see pages 2.1 2.8.
0 @0 • • • 0
0 ANTENNA terminals
Two independent cables or antennas can be
connected to these terminals, Use ANT-A and
ANTB terminals to receive a signal from
VHHUHF antennas or your cable system. Use
the ANTA OUTterminal to send the signal being
received by the ANnA terminal out to another
component (such as a Cable Set Top Box), The
PiP channel can be received only when a signal
source is connected to ANT A.
O
AUDIO-VIDEO MONITOR
OUTPUT jacks
Connect to the audio/video inputjacks of a
recording VCR,
Note: The monitor out does not operate in DVD
or DTV mode.
O
VIDEO INPUT jacks
Connect to the video output jacks of VCRs, DVD
players and similar devices (Two sets are avail
abie: Video1 and Video2),
0 AUDIO INPUT jacks
Connect to the audio output jacks of VCRs, DVD
players and similar devices.
O S-VIDEO INPUT jack
Connect t o anS VHSVCR or DVDplayer.
0 COMPONENT 1(480i, 480p,
1080i) AUDIO/VIDEO INPUT
jacks
Connect a sourcethatoutputs480i/480p/1080i
Y, P L_ a ndP,signals,such asa DVD(or DTV Set-
TopBox.
0 COMPONENT 2, 3(480p,
1080i) AUDIO/VIDEO INPUT
jacks
Connect a source that outputs 480p/1080iY,P,_
and P,_ signals, such as a DTV Set-Top Box,
(The Component3 jack is available on PCM545PJ
HCM422W / HCM474W / HCM553WB /
HCM653WB)