Matte Photo Paper Mp - Canon 2909B002 User Manual

Alarm Lamp Flashes Orange
Nine flashes:
The printer has not received a response
from the digital camera. The digital
camera or digital video camcorder
connected is not compatible with this
printer.
Ten flashes:
Cannot perform duplex printing.
Eleven flashes:
Automatic Print Head Alignment failed.
Thirteen flashes:
Ink level cannot be detected.
during Print Head Cleaning.
Press the
RESUME/CANCEL
the error so you can continue printing. Before the ink
absorber becomes completely full, contact a Canon service
representative. (You will need to replace a particular part of
the printer.)
Check the device connected to the printer. Printing
photos directly is possible only with a PictBridge
compliant device.
A communication time out occurs if an operation takes
too long or if it takes too much time to send data. This
may cancel printing. In such cases, disconnect and
reconnect the USB cable.
When printing from a PictBridge compliant device,
depending on the model or brand of your device, you may
have to select a PictBridge compliant print mode on the
device before connecting it to the printer. You may also
have to turn on your device or select Play mode manually
after connecting the device to the printer. Perform
necessary operations before connecting your device
referring to its instruction manual.
If the error is still not resolved, check if you can print
another photograph.
The size of paper may not be compatible with automatic
duplex printing. The sizes of media suitable for auto duplex
printing are A4, Letter, A5, and 5" x 7". Make sure that the size
of the paper loaded in the printer is correct. Pressing the
button will eject the paper and restart
RESUME/CANCEL
printing from the front side of the next paper. The reverse
side of the ejected sheet will not be printed.
Print Head nozzles are clogged.
Press the
RESUME/CANCEL
and print the nozzle check pattern to check the status of
the Print Head.
Routine Maintenance
Paper of size other than A4 or Letter is loaded in the Rear
Tray.
Press the
RESUME/CANCEL
then load a sheet of supplied paper (Paper For Print
Head Alignment) or A4/Letter-sized Canon Matte Photo
Paper MP-101 with the printing side (whiter side) facing
UP in the Rear Tray.
For Automatic Print Head Alignment, always load paper
on the Rear Tray.
The Paper Output Slot is exposed to strong light.
Press the
RESUME/CANCEL
and then adjust your operating environment and/or the
position of the printer so that the Paper Output Slot is not
exposed directly to strong light.
After carrying out the above measures, if the problem
continues after aligning the Print Head again, press the
button to dismiss the error, and then
RESUME/CANCEL
perform Manual Print Head Alignment.
Manual Print Head Alignment
The remaining ink level cannot be correctly detected. (The
lamp on the ink tank flashes.)
Replace the ink tank and close the Top Cover.
Printing with an ink tank that was once empty may damage
the printer.
If you want to continue printing in this condition, you need to
release the function for detecting the remaining ink level.
Press and hold the
RESUME/CANCEL
seconds, and then release it.
With this operation, releasing the function for detecting the
remaining ink level is memorized. Please be advised that
Canon shall not be liable for any printer malfunction or
button on the printer to cancel
button to dismiss the error,
button to dismiss the error,
button to dismiss the error,
button for at least 5
Стр. 324 из 396 стр.