Table of Contents
Advertisement
HFPI9280, DFPI2311
LIGHT BULB REPLACEMENT
The light bulbs need to be replaced when you notice a dark section of the flame. There
are two bulbs under the log set which generate the flames and embers.
Warning
Disconnect the power before attempting any maintenance or cleaning to reduce the risk
of fire, electric shock or damage to persons.
Warning
Allow at least 10 minutes for the light bulbs and heater to cool before attempting any
maintenance or cleaning.
Bulb Requirements
Quantity 2 clear chandelier or candelabra bulbs with an E-12 (small) socket base, 60
watt rating. Example GE 60BC or Philips 60CTC.
Tools required:
Slot screw driver
1. Remove the fireplace trim.
2. With a slot screw driver remove the two outer screws from the log grate.
3. Slide the light assembly out of the insert by pulling the log grate
until the light assembly reaches the stop (approximately 2")
4. Remove the log set by lifting straight up.
5. Examine the bulb(s) to determine which bulb(s) require replacement.
6. Unscrew the bulbs counter clockwise.
7. Insert new bulbs.
8. Replace the log set into the insert.
9. Slide the light assembly back into the insert.
10. Install the two outer screws into the log grate.
11. Reinstall the fireplace trim.
8
Advertisement
Table of Contents
