Inserting The Npe-G1 Or Npe-G2 Into The Router - Cisco NPE-G2 - Network Processing Engine G2 Installation And Configuration Information

Installing the NPE-G1 or NPE-G2
If the SODIMM appears misaligned, carefully remove it and reseat it in the socket. Push the SODIMM
Step 5
gently back into the socket until the spring latches snap into place.
You have finished replacing the SDRAM SODIMM. To install the NPE-G1 in the chassis, go to the
"Inserting the NPE-G1 or NPE-G2 into the Router" section on page

Inserting the NPE-G1 or NPE-G2 into the Router

If you have difficulty installing a network processing engine or I/O controller in the lowest slot of a Cisco
Note
7200 VXR router that is rack-mounted, remove the port adapters, network processing engine and I/O
controller from the chassis and reinstall them. Install the network processing engine and I/O controller
in the lowest slots first, then populate the slots above them, in a bottom-to-top order.
To insert the NPE-G1 or NPE-G2 into the router, follow the instructions in this section:
Align the left and right edges of the NPE-G1 or NPE-G2 with the chassis slot guides.
Step 1
an NPE-G1 being installed into a Cisco 7200 VXR router; inserting an NPE-G2 is similar. Inserting a
Cisco uBR7200-NPE-G1 or Cisco uBR7200-NPE-G2 in a Cisco uBR7200 series router is similar.
Figure 7-16
1
G I G A B I T E T H E R N E T 0 / 1
L I N K
E N
R J 4 5 R X
1
2
Gently slide the NPE-G1 or NPE-G2 all the way into its chassis slot until you feel the connectors seat
Step 2
with the router midplane.
Seat the NPE-G1 or NPE-G2 in the router midplane by tightening its captive installation screws with a
Step 3
number 2 Phillips or a 3/16-inch flat-blade screwdriver.
Network Processing Engine and Network Services Engine Installation and Configuration
7-28
Aligning the NPE-G1 Between the Slot Guides on a Cisco 7200 VXR Router
G I G A B I T E T H E R N E T 0 / 1
G I G A B I T E T H E R N E T 0 / 1
NETWORK PROCESSING ENGINE - G1
L I N K
L I N K
C P U
R E S E T
E N
G B I C T X E N
R J 4 5 R X
G B I C T X R J 4 5
R X G B I C T X
2
Slot guides
NPE-G1
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
S L O T
A C T I V E
POWER
C O M PA C T F L A S H
ON CONSOLE AUX
4
3 Printed circuit board
4
Metal carrier
7-28.
Figure 7-16
3
shows
OL-4448-12