Configuring The Ipsec Group - Cisco CVPN3015-NR - VPN Concentrator 3015 Getting Started

Configuring the IPSec Group

Click << Add.
Step 2
Repeat Steps 1 and 2 for each user. The screen refreshes each time you add a user.
Step 3
To remove a user, select the user in the Current Users list and click Remove >>. The screen refreshes
Step 4
each time you remove a user. There is no confirmation or undo; to reinstate a user, enter the data in
Step 1.
When you have finished entering users, click Continue to proceed.
Step 5
If you selected the IPSec tunneling protocol, proceed to the section
below. Otherwise, skip to the section
Configuring the IPSec Group
The Manager displays the Configuration | Quick | IPSec Group screen. This screen appears only when
you select the IPSec tunneling protocol, and you must configure these parameters to complete quick
configuration.
The remote-access IPSec client connects to the VPN Concentrator using this group name and password,
which are automatically configured on the internal authentication server. This is the IPSec group that
creates the tunnel. Users then log in, and are authenticated, through their usernames and passwords. (See
Figure
Figure 3-14
In the Group Name field, enter a unique name for this group. The maximum field length is 32 characters.
Step 1
Entries are case-sensitive.
In the Password field, enter a unique password for this group. The minimum field length is 4 characters.
Step 2
The maximum length is 32 characters. Entries are case-sensitive. The field displays only asterisks.
In the Verify field, reenter the group password to verify it. The field displays only asterisks.
Step 3
Click Continue to proceed. You must configure these parameters before you can proceed.
Step 4
VPN 3000 Series Concentrator Getting Started
3-18
3-14.)
Configuration | Quick | IPSec Group Screen
Chapter 3 Using the VPN Concentrator Manager for Quick Configuration
Changing Admin Password, page
"Configuring the IPSec Group"
3-21.
78-15733-03