Kenmore 720-0679R - Gas Grill With Side Burner Use And Care Manual page 11

Installing Cooking Components
Important: Before cooking on your grill the first time,
wash cooking grids and cooking rack with warm, soapy
water. Rinse and dry thoroughly. Season with cooking
oil regularly. After cooking is completed, turn grill to
HIGH setting for 3 to 5 minutes to burn off excess
grease or food residue.
1. Install heat diffusers above burners. Holes in rear
corners of diffusers attach onto pegs in the back ledge
of firebox. Ensure that grill head heat shield is inserted
securely into slots. If grill was shipped with shield taped
in place, remove tape before using grill.
2. Evenly space cooking grids on the ledge above heat
diffusers. (Fig. 16)
3. Slide the warming rack into the brackets in the grill
bowl side panels. (Fig. 16)
Installing Grease Cup
From the back, pull out grease tray, remove any
packaging materials from it, then replace grease cup
into grease tray as shown in (Fig. 17). Push grease
tray back into grill.
Figure 16
Figure 17
Figure 18
Connecting LP Gas Tank to LP Grill
1.Remove the screw on tank bolt & take off the washer.
Insert the tank bolt from rear of the grill and reinstall the
washer & screw set. From Rear of the cart, place foot
ring of 20 Ib tank into the hole in bottom panel. Make
sure the tank valve is in OFF position. Use the tank bolt
to secure the tank in a fixed position (Fig.18).
2. Check the tank valve to ensure it has proper external
mating threads to fit the hose and regulator assembly
provided.
3. Make sure all burner valves are in OFF position.
4. Inspect the valve connection port and regulator
assembly. Look for damage or debris. Remove any
debris. Inspect hose for damage. Never use damaged
or plugged equipment.
5. When connecting regulator and hose assembly to
tank valve hand tighten quick coupling nut clockwise to
a full stop (Fig. 19) Do not use a wrench to tighten
because it could damage the quick coupling nut and
result in a hazardous condition.
6. Open tank valve fully (counterclockwise). Use a
soapy water solution to check all connections for leaks
before attempting to light your grill. If a leak is found,
turn tank valve off and do not use your grill until the leak
is repaired.
CAUTION: When the appliance is not in use, gas
must be turned off at the supply tank.
11
Figure 19
\\\\
\
/
/
Regulator Connection
Congratulations
Your Kenmore gas grill is now ready for use.
Before the first use and at the beginning of each
season (and whenever the LP gas tank has been
changed):
1. Read all safety, lighting and operating
instructions.
2. Check gas valve orifices, burner tubes and
burner ports for any obstructions.
3. Perform gas leak check according to
instructions found on next page of the manual.