End Of Humidification Season; Checking Your Humidifier Operation - Honeywell HE260A Owner's Manual

HE220A,B AND HE260A,B BY-PASS FLOW-THROUGH HUMIDIFIERS
7. Carefully scrape any mineral deposits from the tray and frame. Be sure the frame drain
hole has nothing blocking it.
8. Clean the humidifier pad with a putty knife.
NOTE: If excessive mineral deposits are present, replace with a new pad.
9. Disconnect the drain hose from the drain fitting on the bottom of the humidifier housing.
10. Clean the drain fitting, if necessary.
11. Bend the drain hose to loosen any mineral deposits.
12. lush the drain hose with pressurized water (a running tap) to clean the hose.
13. Reattach the drain hose to the drain fitting.
14. Slide the humidifier pad back into the frame.
15. Snap the water nozzle back onto the tray.
16. Reattach the tray to the frame.
17. Place the humidifier pad assembly in the humidifier housing and press until the assembly
is completely seated. Be careful not to pinch or kink the water feed tube.
18. Replace the humidifier cover.
19. Verify the humidifier operation by following the steps in the Checking the
Humidifier for Proper Operation section.

End of Humidification Season

Clean the humidifier and shut it off at the end of the heating season. Use the Every 1 to
3 Months section, steps 1 through 18 to shut down for the season.
IMPORTANT
Be sure the humidifier power is off.
Vacation
When leaving on vacation, turn off the humidfier water supply and your humidity
control. Turn on the water supply and reset your humidity control when you return.

CHECKING YOUR HUMIDIFIER OPERATION

After winter startup or servicing, check the humidifier operation:
1. Turn on the humidifier power and water supply.
2. Turn the H908A Convertible Humidity Control to the highest setting, or the H1008A
Automatic Humidity Control to the test position, and set the thermostat to 10°F (6°C)
above the room temperature.
69-1111EF-2 6