Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910330 CHAP 17 Manual page 10

FUNS
The FUN Equations
output
values
+1
-1
-1
b = 0
Figure 17-6
sin (a + b), cos (a + b), tri (a + b)
These equations are intended to be used with inputs that are sawtooth wavesÑfor example,
Input a might be LFO1 with its shape set as a sawtooth. Each equation will map a sawtooth-
shaped input into a sine-, cosine-, or triangle-shaped output. Other input waveform shapes will
result in outputs with more complex waveform shapes.
Other ways to get sawtooth shapes as inputs to these FUNs are to use other FUNs as the inputs,
with their equations set as any of the ramp equations described later in this section (see the note
on page 17-18 about the evaluation order of the FUNs). You could also use LFOph1 or LFOph2
as inputs. The Þrst three graphs below show the result of these functions when Input a is a rising
sawtooth wave, and the value of Input b is 0. The fourth shows the result of the sin (f=a + b)
equation when the value of Input b is 0 and Input a is a sine wave.
output
values
+1
-1
-1
sin (a + b)
a = saw
b = 0
Figure 17-7
17-10
output
values
+1
input
+1 -1
values
-1
a = b
(a + b)^2
output
values
+1
input
1 -1
values
cos (a + b)
a = saw
b = 0
sin (a + b), cos (a + b), tri (a + b)
input
+1
values
input
1
values
-1
output
values
+1
-1 +1
-1
a is unipolar
b = .5
output
values
+1
-1
-1
tri (a + b)
a = saw
b = 0
input
values
input
1
values