Eclipse TD307II Owner's Manual page 8

Hexagonal
head bolt
Washer
Tip
7
Steps (7) and after are be followed when using installation example 1 or example 3. Furthermore, the diagram
shows example 1. For example 2 and example 4, refer to the installation example shown in step 6, and make
sure that the speaker base is facing the right way and that the speaker wires are positioned correctly.
Make marks for the speaker base mounting holes.
Speaker base
Approx.
8 in.
(20 cm)
Wire
2
Speaker unit
Speaker wire
(for diameter of less
than 7 mm)
Speaker wire
(7 mm diameter or more)
6
Install the drop-prevention wire to the speaker unit.
Caution
• Attach the drop-prevention wire securely to the
speaker so that the speaker will not fall down.
• Use the hexagonal head bolt and washer which
were removed from the speaker earlier to secure
the wire to the speaker.
7
Use the speaker base to determine the speaker
installation position on the ceiling inside the room,
and then use an awl or similar tool to mark the
positions of the speaker base mounting holes on
the ceiling.
Tip
When marking the positions of the speaker base
mounting holes on the ceiling, attach the speaker
base to the ceiling with tape to make working
easier.
8
Remove the speaker base from the ceiling.
- 8 -