Bissell 9500 User Manual page 11

O
peration
Carpet cleaning (continued)
5. Plug into a proper outlet and turn the
power and heater switches to the ON ( I )
position. Allow 1 minute for the built-in
heater to warm-up before cleaning. The
ProHeat 2X will be fully warmed and will
provide optimal performance after one
minute of continuous heated cleaning.
6. Cleaning Strokes. While pressing the spray
trigger, make one slow forward wet pass
and another one back. Let the built-in heater,
formula, and DirtLifter PowerBrushes do the
work for you. Caution: Do not overwet.
Take care not to run over loose objects or
edges of area rugs. Stalling brush may result
in premature belt failure.
Note: Your machine is equipped with a
circuit breaker that will automatically shut
off the brush if a large or loose object is
caught in the brush roll. If that happens, be
sure to unplug your machine, remove the
foreign object, and then plug the machine
back in to reset the circuit breaker.
Release the spray trigger and make one
slow forward and backward pass over
the same area to remove any residual
dirty water and aid in drying. Repeat
cleaning passes pressing the spray trigger
until solution being pulled up appears clean.
Continue passes without pressing the
spray trigger until you can't see any more
water being pulled up.
7. After cleaning, you may want to turn the
Custom Clean dial to water rinse to give
your carpeting a final water only rinse. This
will ensure thorough removal of embedded
dirt loosened by the deep cleaning formula.
BISSELL deep cleaning formulas contain
an anti-resoiling agent that helps your
carpets repel dirt and keeps them looking
good longer.
8. Remove the tank from the base of the
machine by lifting up on the tank carry
handle. Carry like a bucket to a utility sink
or outside where you will dispose of the
dirty water.
8a. Unlatch the top of the tank from the
bottom by lifting up on the tank latch which
is located on the back of the tank.
w w w . b i s s e l l . c o m
ug120-4042_9500E.indd 11 ug120-4042_9500E.indd 11
5.
Power Switch Power Switch Power Switch Heater Switch
WARNING:
To reduce the risk of fire and
electric shock due to internal
component damage, use only
BISSELL cleaning formulas
intended for use with the
deep cleaner.
Keep plenty of genuine BISSELL deep
cleaning formula and Scotchgard
protector cartridges on hand so you can
clean and protect whenever it fits your
schedule. Always use genuine BISSELL
deep cleaning formulas. Non-BISSELL
cleaning formulas may harm the
machine and void the warranty.
8. 8a.
™
11 16
5/7/08 3:37:44 PM 5/7/08 3:37:44 PM