Table of Contents
Advertisement
M
aintenance and care
Brush removal and large belt replacement
brushes can be removed for cleaning or
replacement as needed.
1.
Follow small belt removal Instructions on
page 18.
2.
Remove brush rolls by pulling them off of
the metal rods.
3.
Place cleaned or new brush rolls back onto the
rods. make sure one washer is on each end of
the rollers prior to sliding onto the rod. Be sure
to let the rod slide through the bushing to
insure proper fit.
4.
Re-attach the long belt on the bottom to the
cogs of the small roller brushes.
5.
Place small belt over back roller and
metal cog.
6.
Place pivot arm in place and screw in place
using the silver screw.
7.
Re-attach clear end cap by tightening with
the (2) black screws.
8.
Return front nozzle to front of unit, by
latching from underneath and then securing
with a screw.
If you have any questions or are having trouble
installing or replacing you belt(s) or brushes,
please call bISSEll consumer Services
T
roubleshooting
built-in heater ready light does not illuminate
possible cause
1. The heater switch is not turned oN ( I ).
2. The power switch is not turned oN ( I ).
Reduce Spray or No Spray
possible cause
1. 2-in1 water tank may be empty.
2. Formula tank may be empty.
3. 2-in-1 water tank may not be
seated completely.
w w w . b i s s e l l . c o m
WaRNING:
to reduce the risk of fire,
electric shock or injury,
unplug from the outlet
before servicing.
2.
4.
6.
8.
Remedies
1. Turn the heater switch oN ( I ).
2. Both switches must be oN ( I ) to
activate the heater ready light.
Remedies
1. Fill heavy duty bladder with hand hot
tap water.
2. Fill formula tank with water and
BISSELL 2X concentrated formula.
3. Turn power off ( O ). Remove and
reseat tank.
3.
5.
7.
19
Hide quick links:
Advertisement
Table of Contents
