Tails Switch - DigiTech HardWire RV-7 Owner's Manual

Tails Switch

The HardWire Stereo Reverb features a switch that allows the reverb signal
to continue being heard after the effect is bypassed. When the Tails Switch is
set ON, the HardWire Stereo Reverb does not utilize true hardwire bypass.
If you always want to use true hardwire bypass, set the Tails Switch to OFF.
When the Tails Switch is OFF, reverb signal is cut off immediately when the
effect is bypassed.
The Tails Switch is located under the Foot Switch and is accessed by press-
ing in one of the Foot Switch Release Pins using the tip of a /" guitar cable
plug. Once the Foot Switch is removed, the Tails Switch is visible inside the
chassis next to the button switch that turns the effect on and off. Slide the
switch to the left to turn Tails ON and to the right to turn Tails OFF.
6