Patch Panels And Cables; Fiber Optic Cables; Figure C-3. Category 5 Utp Patch Cable With Male Rj-45 Plug At Each End - NETGEAR FS566 - Switch Installation Manual

Installation Guide for the Model FS562 and Model FS566 Fiber Switches

Patch Panels and Cables

If you are using patch panels, make sure that they meet the 100BASE-TX requirements.
NETGEAR recommends Category 5 UTP cable for all patch cables and work area cables
to ensure that your UTP patch cable rating meets or exceeds the distribution cable rating.
To wire patch panels, you need two Category 5 UTP cables with an RJ-45 plug at each end,
as shown in Figure C-3.
1
87654321
Key:
1 = RJ-45 plug
2 = Category 5 UTP patch cable
Figure C-3. Category 5 UTP Patch Cable with Male RJ-45 Plug at Each End
Note: Flat "silver satin" telephone cable may have the same RJ-45 plug. However, using
telephone cable will result in excessive collisions and cause the attached port to be
partitioned or disconnected from the network.

Fiber Optic Cables

In North America, use EIA-569-A horizontal 62.5/125-
(ANSI/EIA/TIA-492AAAA).
Internationally, use ISO/IEC 11801 62.5/125-
type A1b, with 1.0db/km attenuation and 500 MHz/km bandwidth). Refer to
minimum requirements of fiber optic cable.
C-4
2
2
2
m multimode optical fiber cable
m multimode optical fiber cable (IEC 793-2
1
87654321
5525.1
Table C-2 for the
Cabling Guidelines