Patch Panels And Cables; Figure C-3. Category 5 Utp Patch Cable With Male Rj-45 Plug At Each End - NETGEAR GS504T Installation Manual

GS504T.Manual.FINAL 6/2/00

Patch Panels and Cables

If you are using patch panels, make sure that they meet the 100BASE-TX require-
ments. NETGEAR recommends Category 5 UTP cable for all patch cables and work
area cables to ensure that your UTP patch cable rating meets or exceeds the distri-
bution cable rating.
To wire patch panels, you need two Category 5 UTP cables with an RJ-45 plug at
each end, as shown in Figure C-3.
1
87654321
Key:
1 = RJ-45 plug
2 = Category 5 UTP patch cable

Figure C-3. Category 5 UTP Patch Cable with Male RJ-45 Plug at Each End

Note: Flat "silver satin" telephone cable may have the same RJ-45 plug.
However, using telephone cable will result in excessive collisions and cause the
attached port to be partitioned or disconnected from the network.
cabling guidelines
12:49 PM Page 28
2
C-4
1
87654321
5525.1