Ldap Import Tasks Remain In A Pending State If Run Simultaneously; Inventory Only Managed Device Is Unable To Post Scans; Inventory Data Of A Managed Device Is Not Displayed For The Linux Primary Server; How Do I Enable Debug Logging - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - ASSET INVENTORY REFERENCE 10.3 30-03-2010 Reference Manual

LDAP Import Tasks remain in a pending state if run simultaneously

Explanation: If an LDAP import task has not finished and you simultaneously run a new
Possible Cause 1: Multiple tasks are running simultaneously.
Action 1: Before running a new task, ensure that all the existing tasks are in a finished
Possible Cause 2: Multiple tasks have been configured to run on the same schedule.
Action 2: Ensure that you do not set the same or simultaneous schedule for multiple

Inventory Only managed device is unable to post scans

Possible Cause: The

Inventory data of a managed device is not displayed for the Linux Primary Server

Explanation: The inventory data of managed devices is not displayed for the Linux Primary

How do I enable debug logging?

140 ZENworks 10 Configuration Management Asset Inventory Reference
where ipaddress is the address of the server.
2 (Optional) To immediately post the scan, restart the zenaa module.
Source: ZENworks 10 Configuration Management; Asset Inventory.
task, the new task is not started and remains in a pending state.
state.
tasks.
Source: ZENworks 10 Configuration Management; Asset Inventory.
uiaconfig.xml
Action: Do the following:
1 In the
uiaconfig.xml
line:
Server="a.b.c.d"
where a.b.c.d is the server IP address.
On Linux,
2 (Optional) To immediately post the scan, restart the zenumia service.
Source: ZENworks 10 Configuration Management; Asset Inventory.
Server in ZENworks Control Center.
Action: Install the inventory-only agent on the Linux Primary Server. The Linux
Primary Server is listed as an unmanaged device in ZCC (Device >
Inventoried).
For information on how to install the inventory-only agent, see
Linux/UNIX" in the
Deployment, and Retirement
Source: ZENworks 10 Configuration Management; Asset Inventory.
Action: To enable the logs, see TID 3418069 in the
(http://support.novell.com/search/kb_index.jsp).
file might be corrupted.
file, add or change the IP address in the following
is located in
uiaconfig.xml
ZENworks 10 Configuration Management Discovery,
Reference.
opt/novell/zenworks/umia
"Installing on
Novell Support Knowledgebase
.