Novell XEN - ADMINISTRATION Manual page 72

16 Log in to the SLE 10 SP1 virtual machine.
17 If you want the SLE 10 SP1 virtual machine to run in GUI mode, complete
17a Enter init 3.
17b Enter sax2 to configure the GUI environment.
17c Enter init 5 to restart the GUI.
18 Open the virtual machine's /etc/inittab file with a text editor.
19 Find the section titled
20 After the line that begins with 1:2345:respan:sbin/mingetty, add
21 Save the file and restart the virtual machine's operating system.
If the mouse pointer stops working within the virtual machine, you might need to restart
the GUI on the virtual machine host by entering init 3 then init 5 on the host's
command line.
After completing these instructions, the updated SLE 10 SP1 virtual machine should
perform correctly. Configuration changes should be made using Virtual Machine
Manager or by modifying xend settings.
66 Virtualization with Xen
After the installation program is completed, the virtual machine should run
SLE 10 SP1 and be registered with xend.
the following from its command line:
# getty-programs for the normal runlevels
the following lines:
2:2345:respawn:/sbin/mingetty tty2
3:2345:respawn:/sbin/mingetty tty3
4:2345:respawn:/sbin/mingetty tty4
5:2345:respawn:/sbin/mingetty tty5
6:2345:respawn:/sbin/mingetty tty6