Troubleshooting Virtual Machine
1 0
Management
The following sections provide solutions to the problems you might encounter while working with
®
the PlateSpin
Orchestrate VM Client:
Section 10.1, "Adding Multiple NPIV Disks to a VM," on page 149
Section 10.2, "Accessing VMs and Host Servers," on page 149
Section 10.3, "Moving or Migrating the VMs," on page 150
Section 10.4, "Registering VM Hosts," on page 151
10.1 Adding Multiple NPIV Disks to a VM
"Duplicate NPIV disks are not allowed" on page 149
Duplicate NPIV disks are not allowed
Source: The PlateSpin Orchestrate VM Client.
Action: When you add an additional NPIV disk to a VM, ensure that the disk values
for Fabric ID, World Wide Name, Target ID, and LUN are unique for each
NPIV disk of the VM.
10.2 Accessing VMs and Host Servers
"VM or host server is not accessible" on page 149
VM or host server is not accessible
Source: The PlateSpin Orchestrate VM Client.
Explanation: A VM or host server does not appear to be accessible for any actions. This
might be because its Enabled check box is disabled. By default, this check box
is enabled.
Action: In the Development Client:
1 In the Explorer panel, expand the Resources section.
2 Browse for and select the VM or host server.
3 Click the Info tab and expand the Info section.
4 For a VM, expand its Resource Information section; for a host server,
5 For a VM, make sure the Resource Enabled check box is selected; for a
6 If you changed the status of the check box, click File > Save to make the
expand its VmHost Information section.
host server, make sure the Enabled check box is selected.
change effective.
You should now be able to perform actions against the VM or host server.
Troubleshooting Virtual Machine Management
10
149