D Network Ports Used By Dsfw - Novell OPEN ENTERPRISE SERVER 2.0 SP2 - DOMAIN SERVICE FOR WINDOWS Manual

Network Ports Used by DSfW
D
This section discusses the network ports that are used by DSfW services to listen on for incoming
network traffic. These ports are configured automatically after the DSfW installation.
Services and Network Ports used by DSfW
Table D-1
Service
Microsoft-DS traffic
LDAP
LDAP Ping
Kerberos
DNS
RPC Endpoint Manager
RCP Dynamic Assignments
Global Catalog LDAP
Global Catalog LDAP over SSL
Network Time Protocol
NetBIOS Name Service
NetBIOS Datagram Service
NetBIOS Session Service
Domain Service Daemon
The RPC dynamic assignment rule allows inbound traffic on any port above 1023. If your firewall
permits this, there is very little reason to enable a firewall. However, you can force
specific port by using the
After restarting the DNS server, refer to
verify that eDirectory and DSfW have been installed and configured correctly.
IMPORTANT: After installing DSfW server into a partition in which you want to configure a
domain, the DSfW server holds the master replica of that partition. This is required because the
master replica holds the FSMO roles for the domain.
Port / Protocol
445/TCP, 445/UDP
389/TCP (or 636/TCP if using SSL)
389/UDP
88/TCP, 88/UDP
53/TCP, 53/UDP
135/TCP, 135/UDP
1024 - 65535/TCP
3268/TCP
3269/TCP
123/UDP
137/TCP, 137/UDP
138/TCP, 138/UDP
139/TCP, 139/UDP
8025/TCP
option. Otherwise, RPC ports are ephemeral.
-p
Chapter 8, "Verifying DSfW Installation," on page 125
to use a
xadsd
to
Network Ports Used by DSfW
D
233