Iprint; Clustering; Changing The Server's Address Configuration; Reconfiguring The Oes Services - Novell OPEN ENTERPRISE SERVER 2 SP2 - PLANING AND IMPLEMENTATION GUIDE 11-10-2009 Implementation Manual

B.2.2 iPrint

If your network users connect to their printers through the print manager on this server, you might
want to consider setting up iPrint Client Management (ICM) prior to the change. ICM lets you
centrally configure the iPrint configuration for your users. For more information, see
Client Management" in the

B.2.3 Clustering

If the server is running Novell Cluster Services:
1 Check your plans against the prerequisites for clusters in
OES 2 SP2: Novell Cluster Services 1.8.7 for Linux Administration
2 Follow the instructions in
guide.
B.3 Changing the Server's Address
Configuration
1 Log into the server you are reconfiguring as the
2 Download and save the
oes2/scripts/ipchangesp2.sh)
3 Open the YaST Control Center.
4 In Network Devices select Network Card.
5 Confirm that the Old IP address you listed in
the IP address currently configured for the network card. You need this later in the process.
6 Using the various dialog boxes associated with the network card configuration, change the card
configuration to the new IP address settings you listed in
page 235, changing each of the following as necessary:
IP Address
Subnet Mask
Router (Gateway)
7 Close YaST, then continue with

B.4 Reconfiguring the OES Services

1 Open a terminal prompt.
2 At the terminal prompt, change to the root (/) directory, make the script executable, then run the
script by entering the following commands:
cd /
chmod 744 ipchangesp2.sh
./ipchangesp2.sh
where oldip is the old IP address, newip is the new IP address, oldmasterip is the IP address of
the eDirectory server specified when the server was installed, and newmasterip is the IP
address of the new eDirectory server identified in
236 OES 2 SP2: Planning and Implementation Guide
OES 2 SP2: iPrint for Linux Administration
"Changing the IP Addresses of Cluster
script file (http://www.novell.com/documentation/
ipchangesp2.sh
to the ( ) partition of the server you are reconfiguring.
root /
Section B.2.1, "General," on page 235
Section B.4, "Reconfiguring the OES Services," on page
oldip newip oldmasterip newmasterip
Guide.
"Configuration Requirements" in the
Guide.
Resources" in the same
user.
root
Section B.2.1, "General," on
Prerequisites above.
"Using iPrint
is in fact
236.