Configuring The Boot Loader With Yast - Novell LINUX ENTERPRISE DESKTOP 11 - ADMINISTRATION GUIDE 17-03-2009 Administration Manual

After rebooting the system and selecting the Linux entry from the boot menu,
the following error message is displayed:
Error 32: Must be authenticated
Press Enter to enter the menu. Then press P to get a password prompt. After en-
tering the password and pressing Enter , the selected operating system (Linux in
this case) should boot.
10.2 Configuring the Boot Loader with
YaST
The easiest way to configure the boot loader in your SUSE Linux Enterprise Desktop
system is to use the YaST module. In the YaST Control Center, select System > Boot
Loader. As in Figure 10.1, "Boot Loader Settings"
boot loader configuration of your system and allows you to make changes.
Figure 10.1 Boot Loader Settings
Use the Section Management tab to edit, change and delete boot loader sections for the
individual operating systems. To add an option, click Add. To change the value of an
(page 103), this shows the current
The Boot Loader GRUB 103