Openslp; Openwbem - Novell BUSINESS CONTINUITY CLUSTERING 1.1 SP1 - 9-21-2010 ADMINISTRATION GUIDE FOR OPEN ENTERPRISE SERVER 1 SP2 LINUX Administration Manual


"Identity Manager 3 Bundle Edition" on page 20

"Installing and Configuring Identity Manager" on page 20
Identity Manager 2 Bundle Edition
Business Continuity Clustering 1.1 Support Pack 1 requires Identity Manager 2.x. Identity Manager
2.0.2 is part of the Identity Manager 2 Bundle Edition (formerly referred to as a Starter Pack) that is
included with OES 1 SP2. For installation instructions, see
Platforms" (http://www.novell.com/documentation/dirxml20/admin/data/abaa3cm.html)
Novell Nsure Identity Manager 2.0.1 Administration Guide.
NOTE: The Identity Manager 2.0.1 documentation also applies to Identity Manager 2.0.2 and later
versions.
Identity Manager 3 Bundle Edition
Identity Manager 3.0.1 is supported with Novell Business Continuity Clustering 1.1 Support Pack 1.
It is included with the Identity Manager 3.0.1 Bundle Edition. Instructions for installing and
configuring the Identity Manager 3.0.1 Bundle Edition can be found with the
Bundle Edition documentation (http://www.novell.com/documentation/oes/implgde/
index.html?page=/documentation/oes/implgde/data/b4dgr2g.html#b4dgr2k).
Installing and Configuring Identity Manager
The node where the Identity Manager engine and the eDirectory driver are installed must have an
eDirectory full replica with at least read/write access to all eDirectory objects that will be
synchronized between clusters. This does not apply to all eDirectory objects in the tree. For
information about the eDirectory full replica requirements, see
8.8," on page
The Identity Manager utilities can be installed on a cluster node, but installing them on a non-cluster
node is the recommended configuration. The management utilities should be installed on the same
server as iManager.
See "Business Continuity Cluster Component Locations" on page 22
where to install Identity Manager components.

2.1.7 OpenSLP

You must have SLP (Server Location Protocol) set up and configured properly. See
OpenSLP for eDirectory" (http://www.novell.com/documentation/edir873/edir873/data/
aksbdp5.html)

2.1.8 OpenWBEM

OpenWBEM must be running and configured to start using
Services Administration Guide for OES (http://www.novell.com/documentation/oes/cimom/data/
front.html).
20 Novell Business Continuity Clustering 1.1 Administration Guide for Linux
18.
in the Novell eDirectory 8.7.3 Administration Guide.
"Installing Identity Manager on Unix
Identity Manager 3.0.1
Section 2.1.3, "Novell eDirectory
for specific information on
"Configuring
. See the OpenWBEM
chkconfig
in the