Advertisement
Endpin jack
Install the endpin jack per Switchjack Installation
Guide.
Mount the preamp
1. Insert the pickup in the saddle slot.
2. Carefully pull back the foil shield on the preamp
(located next to the output cable) to expose the
terminal block.
FOIL SHIELD
TERMINAL BLOCK SCREWS
GROUND WIRE
SIGNAL WIRE
3. Tighten the terminal block screws with a small
slotted screwdriver.
4. Pull the slack on the pickup wire until it lies within
the terminal block compartment, tucked in behind
the screw boss where the wire exits.
5. Check the foil shield sides to make sure that the
shape is intact and the corners are square.
6. Carefully replace the foil enclosure. Note that
when properly installed, the foil enclosure will
cleanly surround both the terminal block and one of
the screw bosses. If the sides of the foil jam up on
the terminal block or screw boss, adjust the fi t so
that the enclosure closes easily.
7. Replace the two screws that hold the foil in place.
Be careful not to cross thread the holes.
8. Angle the preamp 90° from the bezel and
insert it in the cut-out, then fasten the preamp
bezel using the four self-tapping screws and the
two plastic backing plates.
Complete the installation
Install a 9V alkaline battery.
To keep the wires inside the guitar from rattling,
PICKUP WIRE ENTRY
secure them with the included adhesive backed
clips. Attach the wire guide clips to the side of the
instrument.
www.fi shman.com
Self-Tapping Screws
Plastic Backing Brackets
514-300-115 Rev A 5-09
Soundboard
Advertisement
