Miscellaneous Control - JETWAY PM2M - REV 1.0 User Manual

3-11 Miscellaneous Control

This section is for setting CPU Frequency/Voltage Control.
CMOS Setup Utility – Copyright(C) 1984-2004 Award Software
CPU Clock Ratio
Auto Detect DIMM/PCI Clock
Spread Spectrum
** Current Host/PCI Clock is 100/33MHz **
Host/PCI Clock at Next Boot is
** Current DRAM Clock is 133MHz **
DRAM Clock at next Boot is 133MHz
AGP VddQ Select
+2.5V Select
VDIMM Select
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Auto Detect DIMM/PCI Clock
This item allows you to enable/disable auto detect DIMM/PCI Clock.
Spread Spectrum
This item allows you to set the CPU Host/PCI clock and Spread Spectrum.
The settings are: Enabled, Disabled.
Host/PCI Clock at next Boot is
This item allows you to select CPU frequency step by step increasing
The choice are: 100MHz∼132MHz, 133MHz∼200MHz.
DRAM Clock at next Boot is
This field displays the capability of the memory modules that you can use
The choice is either 100MHz or 133MHz (only select CPU Frequency 100MHz.)
AGP VddQ Select
This item allows you to select 1.5V of the AGP 4X VGA card. The choice are: 1.5V, 1.6V.
VDIMM Select
This item allows you to select 2.5V of the DDR Module. The choice are: 2.5V, 2.6V, 2.7V,
2.8V.
Miscellaneous Control
8X
Enabled
Disabled
100/33MHz
1.5V (Default)
2.5V (Default)
Default
F6:Optimized Defaults
33
Item Help
Menu Level >
F1:General Help
F7:Standard Defaults