JETWAY P4MDFTR1A User Manual page 16

Without this connector might cause system unstable because the power supply can not
provide sufficient current for system.
(3) PS/2 Mouse & PS/2 Keyboard Connector : PS2KBMS1
The connectors for PS/2 keyboard and PS/2 Mouse. It can connect with a Y-Cable
which can support 2 Keyboard and 2 Mouse for 2 user function.
(4) USB/USB1 Port connector: USB
The connectors are 4-pin connector that connect USB devices to the system board.
USB1 support 1 port USB2.0 for P4MDFT
USB1 support 2 port USB2.0 for P4MDF
(5) LAN Port connector: LAN
This connector is standard RJ45 connector for Network
(6) Parallel Port Connector (25-pin female): PARALL
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector. The On-
board Parallel Port can be disabled through the BIOS SETUP. Please refer to Chapter 3
"INTEGRATED PERIPHERALS SETUP" section for more detail information.
(7) Audio Connector : CN1
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC for Speaker/
Microphone.
Line-out : Audio output to speaker (Front Speaker for 6-channel solution)
Audio input to sound chip (Rear Speaker for 6-channel solution)
Line-in :
MIC : Microphone Connector (Center/Base Speaker for 6-channel solution)
(8) Serial Port COM1 : COM1
COM1 is the 9-pin D-Subminiature male connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED PERIPHERALS
SETUP" section for more detail information.
(9) VGA Connector (15-pin D-Sub) Connector: VGA
VGA is the 15-pin D-Subminiature female connector for display monitor.
Pin 1
Mouse Y-Cable
Keyboard Y-Cable
PRINT
PS/2 Mouse
13
6-Channel Speaker
LAN