Changing Bulbs For Headlights - Audi A4 Owner's Manual

document_0900452a81b1b9de.book Seite 306 Donnerstag, 26. Juli 2007 9:16 09
306 Fuses and bulbs
Bulb holders with a bayonet fastener
In the case of bulb holders with a bayonet fastener please
proceed as follows:
Removing the bulb holder
– Turn the bulb holder in the direction of the arrow
⇒ fig. 287 as far as it will go and then take the bulb
holder out of the light unit.
Fitting the bulb holder
– Insert the bulb holder into the light unit, making sure you
keep the bulb holder straight, i.e. the rubber seal makes
even contact all around.
– Turn the bulb holder in the direction indicated by the
A ⇒ fig. 287 as far as it will go.
arrow
B

Changing bulbs for headlights

Removing and installing headlights
Fig. 287 Diagram: Bulb
holder with a bayonet
fastener
A
A
The description for removing the headlight refers to the left
headlight; in principle the same procedure applies to the
right headlight.
Removing
– Switch off the ignition and the lights.
– Open the bonnet.
Fig. 288 Trim panel:
Attachment points are
marked by arrows
Fig. 289 Headlight
unit: Attachment
points are marked by
arrows