Asko T721 Quick Start Manual page 2

1. Press the Power button to turn on the machine.
2. Load the laundry into the dryer.
3. Clean the lint filter (see below).
4. Check that the door is clear of laundry then close it firmly. (The door won't shut if it's slammed.)
5. Turn the Timer Control knob to the desired drying time.
6. Turn the Temperature Control knob to the desired setting.
7. Make your program option selections (e.g., Anti-crease).
8. Press Start. The machine will start.
To interrupt a program, simply open the door. The dryer will stop tumbling automatically. To continue the program, close the door and press
Start. The program will continue from the point it was interrupted.
To cancel a program, turn the Timer Control knob clockwise until the dryer stops or press the Power button to turn off the power.
Although the lint in your ASKO dryer will be minimal, the lint filter should be cleaned after each load to
ensure maximum air flow and prevent possible overheating. To clean the filter, follow the steps below:
1. Grasp the handle and pull it toward you.
2. Remove the filter from the holder by pulling it up.
3. Open the filter and gently brush away any lint.
4. Fold the filter together and return it to the holder on the door.
5. Push the holder in until it snaps into place.
If the dryer is not installed to pump out the condensed water into a drain or sink, you
should empty the water container every three to five dryer loads, depending on the
spin speed you use when you wash the clothes. For example, clothes spun at 800
rpm will have more moisture when you take them out of the washer than clothes
spun at 1400 rpm. Therefore, the dryer will have to remove more water.
To empty the container, simply pull it out and pour out the water. This water is clean
and can be used to water plants.
If the container becomes too full, the machine will shut down. To restart the program,
empty the container and press Start. It may be a few minutes before the machine
starts because it drains the excess water from the sump before it restarts.
Do not remove the water container while the machine is running.
NOTE:
The dryer has a protection device that shuts the machine off if the temperature becomes too high. Overheating could occur if the lint filter is
clogged or the fan or condenser unit needs to be emptied or cleaned. If the dryer shuts off during a program, first make sure the condensation
water container is empty. If that isn't the problem, check the lint filter. Lastly, it could be the fan or the condenser unit needs to be cleaned. See
page 3 in your Use and Care Guide for more details.
NOTE: We recommend that you clean the lint filter after every load.
Simply pull out the container
and pour out the water.