Midland WR-300 - MANUAL 2 Manual page 22

"SINGLE" or "MULTIPLE", press SELECT to proceed to
programming codes. The next display will display "CODExx"
above six numbers or dashes for numbers. If "SINGLE" was
chosen, only the CODE01 setting will be used. These numbers
will determine the areas or counties that your WR-300 will be set
to respond to SAME messages. See "Acquiring FIPS Codes for
Your Area" for how and where to find the codes for your area.
To change the first code displayed, press and release the
SELECT button to change the code displayed or the UP arrow
key to select another code position. If you pressed SELECT the
display will now flash the first digit of the six digit code. Press
and release the UP or DOWN buttons to set the FIPS code digit
you want. Use the LEFT and RIGHT arrow buttons to change
digits. When the display shows the correct number press and
release the SELECT button. This accepts the code you entered.
The code number now will flash. If you wish to program another
county code, press the UP button to go to the next code location.
When you have entered all the desired codes, press and release
the "MENU" button to store your settings.
Reviewing stored "FIPS" codes
Enter the program mode as described earlier. press and release
"MENU" button. Press the UP or DOWN arrow button until
"COUNTY CODE " is displayed in the left side of the display.
When the "FIPS" codes are displayed, press and release the "UP
or DOWN arrow" keys repeatedly to review all memory locations
you desire. All empty memory locations will be "------". When
finished reviewing the "FIPS" codes press and release the MENU
button.
ALL County Codes option
To cause the WR-300 to receive all SAME messages without
regard to area, choose ALL when COUNTY CODE is selected in
the programming menu. If you have not selected a weather
21