Table of Contents
Advertisement
Step 7. Installing the fillers on a slanted I/O tray
Notes:
1. Ensure that the side of each filler overlaps the tab on the side of the I/O tray.
2. If you are using an IBM 4610 SureMark printer with magnetic ink character
Figure 32 through Figure 35 on page 42 shows the locations of the fillers and the
method for installing them. Insert the tab in the slot and push the filler toward the
tab until it snaps into place.
Figure 32. Mounting locations for the fillers
Note: The dashed lines indicate possible locations for mounting each filler panel.
40
SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Planning, Installation, and Operation Guide
recognition (MICR), install it on the right side. This arrangement minimizes the
effect of magnetic interference from the CRT on the MICR in the printer.
A
C
A
Credit card holder
B
Display
C
Keyboard
D
Keyboard replacement
Updated October 31, 2007
B
D
Advertisement
Table of Contents
