Mounting Of Temperature Probe - Whistler CRUISADER Installation Instructions Manual

Cruisader Installation.qxd
Installation of Laser-Radar Antenna
Mount the antenna to the vehicle such that the ANTENNA
window is facing the road surface, sky, right or left of the
vehicle, and the reflector has an unobstructed view of the
road ahead.
Mounted in this position, radar signals are reflected into the
ANTENNA window; however, the unit will not be able to
receive laser signals.
Mounting the Temperature Probe
Find a location that is far enough away from the engine and
radiator heat but still in the airflow for the vehicle. Mounting
the Probe too close to these heat areas will give a false high
temperature.
• Attach the mountable tie wrap (supplied) to the
Temperature Probe as shown.
• Mark location for Probe, then drill a hole using a 7/64" drill
bit. Attach Probe with tie wrap in the correct orientation
using the #6 x 3/4 screw.
Note: Mount the Probe so that there is space between the
Probe and the mounting area.
Do not mount Probe directly
to metal area.
5/24/05 9:00 PM Page 13
Mountable
Tie Wrap
Temperature
Probe Cable
Probe
Mounting Location
11
Installation of Laser-Radar Antenna
Antenna Cable to the Control Panel
Once the antenna is installed, connect the cable from the
laser-radar antenna to the quick disconnect cable on the
control panel. Tie this cable in knot similar to using an
electrical extension cord. Be careful not to interfere with or
disconnect other wires, cables, or mechanical systems of your
vehicle while routing the antenna cable. Also, keep the
antenna cable away from any areas around the engine
compartment that may become hot. Cable ties are provided
to secure the antenna and Temperature Probe cables at
various points on the frame.
Label on back of Control Panel Indicates what each wire goes to.
12
P P W W R R
- 12 Volt Connection
A A U U X X
- LED, Tone Voice Module Output
L L A A S S
- Laser Module Input
A A N N T T
- Laser-Radar Receiver Input