System Requirements
System Requirements
Memory Requirements
OmniSwitch 6800 Series Release 6.1.3.R01 requires 256 MB of SDRAM and 64MB of flash memory.
•
This is the standard configuration shipped.
OmniSwitch 6850 Series Release 6.1.3.R01 requires 256 MB of SDRAM and 64MB of flash memory.
•
This is the standard configuration shipped.
OmniSwitch 9000 Series Release 6.1.3.R01 requires 256 MB of SDRAM and 128MB of flash
•
memory. This is the standard configuration shipped.
Configuration files and the compressed software images—including web management software
(WebView) images—are stored in the flash memory. Use the show hardware info command to deter-
mine your SDRAM and flash memory.
UBoot, FPGA, Miniboot, BootROM, and Upgrade Requirements
Note. Field upgrade of existing OmniSwitch units is required prior to loading this release. See the Upgrad-
ing OmniSwitch 6800, 6850, and 9000 Series Switches to 6.1.3.R01 upgrade instructions for more informa-
tion.
The software versions listed in this section are the minimum required, except where otherwise noted.
OmniSwitch 6800 Series
Miniboot: 6.1.2.49.R03 or later
•
BootROM: 6.1.2.49.R03 or later
•
OmniSwitch 6850 Series
UBoot: 6.1.3.601.R01 or later
•
Miniboot.uboot: 6.1.3.601.R01 or later
•
OmniSwitch 9000 Series
UBoot NI: 6.1.1.167.R02 or later
•
UBoot CMM: 6.1.1.167.R02 or later
•
Miniboot.uboot CMM: 6.1.1.167.R02 or later
•
FPGA CMM: Major Revision: 2 Minor Revision: 25 (displays as 0x19)
•
POE Firmware
5.01
•
page 4
OmniSwitch 6800/6850/9000—Release 6.1.3.R01