Echo SRM-2400 TYPE 1E - 09-99 Operator's Manual page 19

SRM-2410
14B. Connect ignition stop lead (A). Install ground lead with bolt (B).
15. Remove left side clutch case bolt (P). Install metal bracket clamp
(Q) with curved end down. Install throttle linkage into bracket
clamp and pinch tight with pliers.
16. Loosely fold ignition leads and retain them with black wire holder
(N).
17. Install air filter and cover.
18. Balance unit.
a. Put on harness and attach unit to harness.
b. Slide harness clamp (R) up or down until unit balances with
cutting attachment approximately 2 - 3" from ground.
c. Tighten harness clamp screw.
G T
RASS RIMMER
O
PERATOR
A
/B C
RUSH UTTER
' M
S ANUAL
B
P P P P P
Q Q Q Q Q
N N N N N
R R R R R
19