Settings Mode - BRAX Installation Instructions Manual

Settings mode:

d A
d P
Channel 1: display average mode
Channel 2: display peak mode
r 2. 0
Channels 1 & 2:
refresh rate adjustment
b 10
Channels 1 & 2:
brightness adjustment
o110
o 55
Channel 1 and 2:
over-temperature adjustment
t !(
Channels 1 and 2:
temperature scale selection
Display Average/Peak
Select what type of value you want to be shown,
average measured thru one period
"d P". This setting is individual for each channel.
Refresh rate
Select refresh rate = measurement period in seconds
"r 0.1". Minimum is 0,1sec, maximum is 3,0sec. This
setting is common for both channels.
Brightness
Select desired brightness of display
Minimum = the darkest is 1,
Maximum = the brightest is 10.
This setting is common for both channels and it is
stored in EEPROM memory separately for two possible
car light conditions i.e. when the lights are turned on
the selected brightness could be 3 and when the lights
are turned off the selected brightness could be 8. This is
useful when driving in the night and you do not want to
be disturbed by too bright a display.
Over-temperature
Select over-temperature by which external fan outputs
are to be switched on "o
below your selected over-temperature the fan output
stays low=fan is stopped. For temperatures equal or
above over-temperature the fan output is the drive
current =fan is running. Minimum is 50°C, maximum is
120°C. This setting is individual for each channel.
Temperature scale
Select temperature scale from these two options:
degrees Celsius "t
"t °F". This setting is common for both channels and it
also affects how the over-temperature values are indica-
ted.
"d A" or peak
"b 1".
50". As long as temperature is
°C" or degrees Fahrenheit