Normal Mode - BRAX Installation Instructions Manual

General:
V V V V O O O O L L L L T T T T
14. 4
V V V V O O O O L L L L T T T T
14. 4
are not valid data. Press button 1 briefly to show next quantities for channel 1 or do the same with
button 2 for channel 2. When you press button 1 for more than 2 seconds you enter the setting mode.
Once in setting mode you can change common (refresh rate, brightness and temperature scale) and
individual (average/peak, over-temperature) settings for channel 1 by short depression of button 1 and
individual settings for channel 2 by short depression of button 2. The return from any setting mode
back to normal mode is performed automatically when none of the buttons has been pressed for a ti-
me longer than approx. 3 seconds.

Normal mode:

V V V V O O O O L L L L T T T T
Lo
V V V V O O O O L L L L T T T T
11. 8
Channel 1: under-voltage condition
120
P P P P O O O O W W W W E E E E R R R R
A A A A M M M M P P P P E E E E R R R R E E E E
Km
Channel 2: over-voltage condition
Kot
T T T T E E E E M M M M P P P P
109
T T T T E E E E M M M M P P P P
Channel 1: maximum temperature
condition
-3
T T T T E E E E M M M M P P P P
(old
T T T T E E E E M M M M P P P P
Channel 2: minimum temperature
condition
After power-on the display is in nor-
mal mode and shows the voltage for
both channels 1 and 2. Please re-
Button 1 (channel 1)
member that the values shown for
either channel may not be correct un-
Button 2 (channel 2)
til the display receives the first data
measured from the mainboard. So if
you have the refresh rate selected=3,0
sec then within the first 3 seconds af-
ter display starts up the values shown
Voltage is shown with a resolution of 0,1V. Should the-
re be under-voltage condition (voltage < 8,0V) the dis-
play shows "Lo". Should there be over-voltage condi-
tion (voltage > 18,0V) the display shows "Hi".
Current is shown with a resolution of 0,1A. The same
rules as for voltage apply to under-voltage and over-
voltage conditions.
Power is shown with a resolution of 1W. The same ru-
les as for voltage apply to under-voltage and over-volta-
ge conditions.
Temperature is shown with a resolution of 1°C or 1°F
depending on temperature scale currently selected.
Should there be maximum temperature (same result as
if temperature sensor was not connected) the display
shows "Hot".
Should there be minimum temperature (same result as
if temperature sensor was shorted) the display shows
"Cold".