Installing The Cooling Fan(S) - TYAN TOMCAT I815T User Manual

Installing the Cooling Fan(s)

After a CPU has been installed, you will need to install the proper cooling device for the CPU. This
device, a heatsink/fan combination, can be purchased at many computer retail stores. Installation of the
cooling device may vary depending on the fan manufacturer's design. You should also take space into
consideration when install a cooling device: make sure the cooling device is not too big, or else you may
end up damaging components around the CPU socket.
Tyan highly recommends that you use some type of
thermal compound (available from many computer retail
stores), between the CPU and heat sink, to maximize
distribution of heat away from the CPU. Please use extra
caution when installing any type of clamp-style fan, or
else damage may occur to the CPU socket, and/or the
CPU itself. See the picture to the right for an example
of how to connect the cooling fan's power supply.
Another diagram has also been provided below, to aid in
CPU fan installation onto the socket. Check with your
cooling device vendor for more details about installation.
Can be used to install
a cooling device
Mounting points on the CPU socket
ground
The FAN connector has a 12V, 1.2A limitation. Tyan takes no responsibility
NOTE:
and will not be held liable for damage related to the misuse of any FAN jumper.
Installing Chassis Fans
Alternatively, if you wish to also install chassis fans for increased cooling, headers are provided to power
those fans as well (see p. 14, section 2.6-H). Chassis fan installation will vary depending on your chassis
manufacturer's design. Please check with your chassis manufacturer for details on proper chassis fan
installation.
Tomcat i815T S2080
FAN
1 2 3
+12V speed
Close-up of fan connector
Specifications
Voltage 12V
Amperage 1.2A
21