Installing Expansion Cards - TYAN TOMCAT I7230A User Manual

Tomcat i7230A S5160
Troubleshooting Floppy Drives
See the chart below for troubleshooting floppy disk drive installations.
Symptoms of incorrectly installed floppy drives
Drive is not automatically detected
Drive Fail message at boot up
Drive does not power on
Drive activity light is constantly on
2.8 – Installing Expansion Cards
Before installing add-in cards, it's helpful to know if they are fully compatible with your
motherboard. For this reason, we've provided the diagrams below, showing the most common
slots that may appear on your motherboard. Not all of the slots shown will necessarily appear
on your motherboard, however, there will be combinations of what you see here.
Simply find the appropriate slot for your add-in card and insert the card firmly. Do not force any
add-in cards (or anything else) into any slots if they won't seat in place. It's better to try
another slot or return the faulty card rather than damaging both the motherboard and the add-
in card.
TIP: It's a good practice to install add-in cards in a staggered manner, rather than directly
adjacent to each other. This allows air to more easily circulate within the chassis, providing
improved cooling for all installed devices.
Unplug the power connector to the motherboard before
performing system hardware changes, to avoid damaging the
board or expansion cards
Usually caused by faulty cables, cables put in
backwards or a faulty floppy drive. Try another
floppy drive or try replacing the cable. Check to
see if the onboard floppy controller is enabled in
the BIOS setup.
The cable, floppy drive or motherboard may be
faulty. Try another drive or cable.
Check power cable and cabling. A faulty power
supply or drive cable could be the problem.
Usually signifies that the cable on the drive is
inserted backwards. Reverse the cable at the
floppy drive end and try again.
Notes
19
http://www.tyan.com
Chapter 2: Board Installation