Reset Connector: J49
Turbo LED Connector: J50
Flash EPROM: J54
This jumpers should be left at the factory default.
Keylock Connector: J40
CMOS Resest/Password Reset: J43(Default off)
If you forget your CMOS password or need to reset the
CMOS registers, just power off the system and close
jumper J43 for five seconds. Then open jumper J43 and
power on the system. This will set the CMOS and password
back to the system default.
S1469-001-01 http://www.tyan.com
Pinout Assignment
1
Power Good
2
Ground
Pinout Assignment
1
Cathode
2
Anode
J54
1-2
Pinout Assignments
1
Led Output
2
No Connect
3
Ground
4
Keylock
5
Ground
10