Table of Contents
Advertisement
6.5
hanGinG uP
to terminate a call when no calls are on hold, Tap the headset multifunction button. you can also terminate a call
using the native controls of your mobile phone or softphone. If you are using an unsupported softphone,
then you must always use the softphone's native interface to hang up.
Figure 12: hanging up
6.6
contRollinG the SPeakeR voluMe and MicRoPhone
the headset features a touch panel that is similar to the touch pad included with many laptop computers.
Use it to adjust the volume you hear in your headset and to mute/unmute the microphone.
- slide your finger up the touch panel (away from your mouth) to increase the volume.
- slide your finger down the touch panel to decrease the volume.
- double-tap on the touch panel to mute or unmute the microphone.
Figure 13: using the volume strip and mute control
Note: a tone will sound to indicate each new volume setting; a double tone indicates that you have
reached maximum or minimum volume. you will also hear a soft tone in the headset to remind you when
microphone muting is active; this signal will repeat occasionally until you reactivate the microphone.
If you hang up while the microphone is muted, it will automatically be re-enabled the next time you place
or answer a call.
6.7
SwitchinG between youR Phone and headSet
It is possible to enable or disable the headset without interrupting your current call. the procedure is intuitive but
slightly different depending on which type of phone you are using, as outlined below.
- For mobile phones, the procedure for switching to and from the headset varies by phone model. please see
your mobile phone documentation for details.
- For softphones, your headset is likely to be your only option, but if other audio devices are connected to your
pC, you may be able to switch to them by changing the audio preferences for Windows and/or your softphone
program.
Jabra GO 6430 User manUal
2 x
20
Advertisement
Table of Contents
